Accidental fire alarm activation at Hillside Dr, Raymond NH
Fire & ArsonA fire alarm went off at a location near Hillside Dr. The alarm was triggered accidentally and only affected the caller's unit. There was no smoke or fire seen. The fire system was reset and the response units were reduced accordingly.
Audio|Source: Essex and Southern Rockingham Counties Fire / EMS
02:9
Transcript:
00:00
Fire alarm.
00:02
This was an accidental pulsation activation.
00:05
Both stations been reset, system's been reset,
00:08
engine one, car two boat clear, commands terminated returning.
00:13
Accidental system reset, you're returning.
00:23
Sir, please, and fire notes can't full response.
00:25
We need a (number withheld) names held drive for a fire alarm activation throughout the building.
00:31
Again, it's going to be full response to (number withheld) namesill drive for a fire alarm activation.
00:36
Before the view throughout the building.
00:42
Bye, I'm catching.
00:50
High alarm, car two.
00:55
Car two.
00:58
Car two, engine one, back in.
01:03
Preachie. Two,
01:05
two.
01:13
This spurred from engine three, 15.
01:19
Number 3, now (number withheld) inch so be advised. It's only going to be the callers unit.
01:36
Is the building in alarm right now?
01:43
Negative, reported by the caller.
01:45
Caller just stated his unit only,
01:47
no smoke or flames.
01:51
Okay, reduce it to myself from the engine 3.
01:57
You have card 3, engine 3 to handle. Fixed by you do, engine 1, engine 2, you guys can remain in Cordes.
02:08
Engine 2 has that.
Disclaimer:
This transcript was automatically generated and may contain inaccuracies. Please verify the information independently.
Location mentioned:
Hillside Dr, Raymond, NH 03077
This shows a Google Street View of the area near the location, which might not be the exact address.
Correct
Incorrect
