Fire dept responds to sparking wires alarm at terminal, Plainview NY
Fire & ArsonFire department responded to a report of sparking wires behind a terminal building. They could not enter at first but later gained access. The alarm panel was found off due to a power outage. No fire or downed power lines were found. The alarm company was notified for inspection.
Audio|Source: Nassau County Fire - Battalion 6 and 9
03:8
Transcript:
00:00
That's through R&P 222. He states that there might be...
00:03
They received this as possible wires sparking in the back of one terminal.
00:07
We're unable to gain entry.
00:09
Nobody's entry in the door.
00:11
We're going to take a 360 around.
00:13
And we're going to take up.
00:15
We're going to take up.
00:24
I'm going to be.
01:04
9-0 to 9.24, 21 dash.
01:07
201 gasp. 22nd.
01:14
22nd. No fire signal.
01:17
We can ask the information.
01:19
No.
01:32
920321
01:35
21 21 have been 1335 it's going to be through here 23
02:00
950 come ahead the tree down on Nick and Manetta Hill DPW is in the process of removing
02:14
All right, 2nd33, Chief, do you want any separate run generator for that or is that one of the same as where you're at?
02:19
No, you can generate the second one.
02:21
All right,
02:23
go right there, just repeat the actions again, please.
02:26
It's about 100 feet from Big and that hill in place.
02:34
Tonight, Richard. Chief.
02:45
9950.
02:48
One terminal drive we were able to gain access the alarm panel is out due to a power outage.
02:55
Their systems in trouble, they were notified to contact the alarm company to service,
02:59
and there is no power lines down or smoking in the rear location as well.
03:03
All right, 23, 1336.
Disclaimer:
This transcript was automatically generated and may contain inaccuracies. Please verify the information independently.
Location mentioned:
Terminal Dr, Plainview, NY 11803
This shows a Google Street View of the area near the location, which might not be the exact address.
Correct
Incorrect
