Fire alarm caused by accidental panel test in evergreen lane, Bloomington IL
Fire & ArsonA fire alarm was triggered at a location near Evergreen Lane in Bloomington. Firefighters investigated and found it was caused by an accidental test of the alarm panel. No fire or emergency was found, and units were cancelled.
Audio|Source: Bloomington and Normal Fire
01:10
Transcript:
00:00
McComb, Rescue 13th on scene, near Evergreen Ln.
00:06
Concee 1415.
00:07
2012 is unseen of a small, single-story restaurant with nothing shown.
00:11
We'll be on the investigation mode.
00:13
Engine 12 will have Veterans Command.
00:16
We'll be operating on fire ground red.
00:21
Andrew 12 on scene, 1450.
00:27
METCOM from Veterans Command.
00:31
Go ahead.
00:35
Netcom, you can cancel all incoming units.
00:38
This was a panel that was being tested and the alarm accidentally went out.
00:44
We're going to remain on scene for a few more minutes.
00:47
Stand 4. I'll show you and it's clear.
00:54
Back on from Veterans Command.
01:00
Go ahead.
01:03
Back on, this was testing of the system.
01:06
The alarm wasn't made to go through.
01:08
There's no problem here.
01:09
Commands terminated.
Disclaimer:
This transcript was automatically generated and may contain inaccuracies. Please verify the information independently.
Location mentioned:
S Evergreen Ln, Bloomington, IL 61704
This shows a Google Street View of the area near the location, which might not be the exact address.
Correct
Incorrect
